You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Every time after a power failure, the blinds think they are in the down position and try to open fully. As a result, the web is wound on the roller to a critical level, which leads to jamming and overheating of the motors.
I do not use the connection of the hall sensor, which is indicated in the firmware as an position sensor of the blinds.
Calibration procedure does not solve the problem.
The text was updated successfully, but these errors were encountered:
Every time after a power failure, the blinds think they are in the down position and try to open fully. As a result, the web is wound on the roller to a critical level, which leads to jamming and overheating of the motors.
I do not use the connection of the hall sensor, which is indicated in the firmware as an position sensor of the blinds.
Calibration procedure does not solve the problem.
The text was updated successfully, but these errors were encountered: