You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
hi Antonello,
I would like to ask you some question about ENVI-MEt and MORPHO.
In the rhino modeling file, only the x, y axes appear and the z axis does not appear.
I'd like to know how to solve it. The version is using rhino6. thanks.
by seunghyeo
The text was updated successfully, but these errors were encountered:
hi Antonello,
I would like to ask you some question about ENVI-MEt and MORPHO. If you look at the picture, you'll see a panel called 0,1,2.
I connected the panel to morpho_decomp_grid in the same way
There's an error. I'm leaving a fingerprint because I'm curious about the reason. Thank you.
Hello Antonello, I have a similar issues to the previous post (my brep edges component is also red and I do not know what the panel with 0,1,2 is indicating) In general I need more documentation about how to set up the morpho workspace, location, grid, and model. The components I see, in some cases, are slightly different than what is shown on the wiki. I am reaching out to the ENVI-met developers as well. Thank you!
hi Antonello,
I would like to ask you some question about ENVI-MEt and MORPHO.
In the rhino modeling file, only the x, y axes appear and the z axis does not appear.
I'd like to know how to solve it. The version is using rhino6. thanks.
by seunghyeo
The text was updated successfully, but these errors were encountered: