Push in Dynamo

Note: It is highly recommended to switch to Manual mode when working with Dynamo and BHoM. Besides that, it is worth having a look at Using the BHoM section before reading this page.

Basics

Having the adapter successfully set up, one can start interacting with Revit. Similar to Pull, Push behaves like a standard Dynamo component, so can be placed on canvas with a standard right click action. The objects to be pushed need to be BHoM objects and should generally be one of the types supported by BHoM conversion to Revit.

The example below shows a simple exercise of pushing a level to Revit. There is a few details that might be worth noticing:

• Whole BHoM operates on SI units, which means that in order to create a level on 9.000, one needs to input elevation equal to 9 units.
• Push will not run as long as it is not activated (active == true).

Pushing elements

The example above

ModelInstances and DraftingInstances

Update

Note: Update is currently in prototype stage and might not always work as expected.