Internal GPS

[stevempotter]

I am trying to get the internal GPS I installed in my Radiomaster TX16S (with EdgeTX 2.8.2) to display GPS coordinates of the radio in a widget. Does anyone know how to do that?
Also, I see only NMEA and DMS options for the formatting of the coordinates. I would prefer just decimal degrees, such as
54.1234567, -6.1234567
as these are much easier to type into Google Maps if needed. Can you add that to the next version of EdgeTX?

I can see a little satellite icon in the top bar that shows me how many satellites it is seeing, and can see it is working in the Statistics:Debug window.

[pfeerick]

Maybe have a look at some of the Lua GPS widgets - https://github.com/moschotto/OpenTX_GPS_Telemetry and https://github.com/kristjanbjarni/opentx-widgets

[rotorman]

Included on stock EdgeTX SD card is a radio GPS test widget that you can tweak for your purpose: https://github.com/EdgeTX/edgetx-sdcard/blob/master/sdcard/c480x272/WIDGETS/TxGPStest/main.lua

[smcStevesmc]

Therer are 4 pads for rx/tx/3v/grnd you can solder on inthe board. Remove 4 screws from back case and two from next to the antenna, not too hard.

HOWEVER, I installed a HGLRC M100 but it isnt working.. I trried the same 2 units on my drone and they worked fine, but my TX16S just isn't recieving data....Itried swapping rx and tx too..any ideas?

[rotorman]

Can you first try to hook up your HGLRC M100 GPS via FTDI cable to your radio and verify with a terminal program, such as hTerm, that it really is outputting NMEA at 9600 baud 8N1.
The product page lists 115200 baud and UBLOX protocol as default for this GPS: https://www.hglrc.com/products/m100-5883-gps and I remember reading that some uBlox M10 based GPS do not allow settings to be saved. You could test also with u-center 2 software.

And EdgeTX would surely be happy to receive a PR with uBlox protocol support. For hints, how this could be done could be taken e.g. from: https://github.com/betaflight/betaflight/blob/master/src/main/io/gps.c

[pfeerick]

FYI, this is a cross post as was also asked in #4562