-
Notifications
You must be signed in to change notification settings - Fork 74
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Not Connecting to WiFi #1
Comments
I built the latest code (8d5b4be). Then flash the firmware to D1. To make sure D1 is in WIFI AP Mode, type ifconfig in console
Then I switching it to WIFI Client mode, type ifconfig in console.
Seems OK. |
I couldn't setup wireless access too. Looks like my rtl8188eu chip revision does not work with
|
I am also facing the same issue, the camera is not showing any SSID. i tried 3 different USB WiFi dongle but no luck. Not sure where to look for help. Very poor documentation. Thanks |
What firmware version are you using?
|
Although my post is almost a year and a half old, I am still having this issue, the units I own are now living in a drawer. |
Just to make sure, do you aware of the fact that the USB sockets are not
|
I am following the exact procedure in the documentations to connect it through AP mode. But no AP is available to connect with. If you want I can send you a video of my procedure. Something is wrong with the board or the documentation. I need immediate help, else will open a dispute case with seller for selling faulty board. |
Sorry to hear that.
|
I am using the Banana Pi D1 with the official Banana Pi WiFi Module. I am able to boot the device and connect to it when it is broadcasting as an AP.
From the wireless table I found my wifi network at saved my password. The instructions say that once this is saved to press the function key and it will switch to slave mode and the LED will blink. It does blink but only for a second and then goes back to solid and does nothing.
I've been told you have to edit /etc/jffs2/camera.ini, the [wireless] block. I have not been able to connect over serial but either way the fact it isn't working from the control panel seems like an issue. Any advice? I am using the latest 2.0 image.
http://bananapi.com/index.php/forum/general-discussion-for-bpi-d1/564-connect-to-wifi
The text was updated successfully, but these errors were encountered: