-
-
Notifications
You must be signed in to change notification settings - Fork 327
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
8bitdo DIY Kits (NES, SNES, N64) not resyncing after cold reboot / powercycle on MiSTer v230423 OS v230501 #856
Comments
Keeping MiSTer v231018 while reverting OS to v230501 is fixing this issue. |
Do those controllers have a Nintendo Switch mode? If so, switch from that mode to XINPUT instead and see if the behavior continues. |
I did test that. Only reverting to OS v230501 is fixing this issue. |
If you unplug and then plug in the bluetooth adapter you are using after the cold reboot, does it pair? |
No it doesn't. Need to re-pair after every power cycle / cold reboot no matter if unplugging or not. OS v230501 is working flawless. |
Are you absolutely certain? The new drivers added are only for Switch controllers, no other driver changes (aside from gamecube adaptor and stadia, which shouldn't be relevant here) are included between those versions. If those controllers are using Nintendo vendor ID + device ID in other, non-switch modes that would be a problem, we would need to find some way to differentiate from actual Switch controllers. |
Hi, yes I am 100% sure Tested on two different Misters. 8bitdo DIY Kits
not resyncing after v230501. Had to buy new controllers.
Shig ***@***.***> schrieb am Do., 28. Dez. 2023, 00:44:
… I did test that. Only reverting to OS v230501 is fixing this issue.
Are you absolutely certain? The new drivers added are only for Switch
controllers, no other driver changes (aside from gamecube adaptor and
stadia, which shouldn't be relevant here) are included between those
versions. If those controllers are using Nintendo HID + device ID in other,
non-switch modes that would be a problem, we would need to find some way to
differentiate from actual Switch controllers.
—
Reply to this email directly, view it on GitHub
<#856 (comment)>,
or unsubscribe
<https://github.com/notifications/unsubscribe-auth/ALIUWYEPNEUNQUQHJ66TMLDYLSXHDAVCNFSM6AAAAAA77AWAWKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTQNZQGY4TKOJQGE>
.
You are receiving this because you authored the thread.Message ID:
***@***.***>
|
After updating to MiSTer v231018, OS v231108 my 8bitdo DIY BT Controller Kits (N64, NES, SNES) will not resync after a cold reboot / power cycle.
Going back to MiSTer v230423, OS v230501 everthing is working / resyncing fine again.
The text was updated successfully, but these errors were encountered: