Replies: 5 comments 10 replies
-
Read the page down to the end, GPIO is given here: https://templates.blakadder.com/sonoff_THR316.html |
Beta Was this translation helpful? Give feedback.
-
Thank you both! |
Beta Was this translation helpful? Give feedback.
-
@AdamaFla Have you been able to use the THS01 by configuring the sensor as a SI7021? I tried to use the THS01 as a SI7021 in esphome and I couldn't read its values successfully. |
Beta Was this translation helpful? Give feedback.
-
I was thinking of getting one of these. Do you have any notes or directions on how to flash it? I've flashed some Sonoff power outlets to Tasmota. And is it working OK for you with proper temperature readings and such? I wasn't sure about some of the comments here. |
Beta Was this translation helpful? Give feedback.
-
@AdamaFla do you have original firmware for THr316 that you could share? I've removed mine accidentally and can't make firmware restore :/ |
Beta Was this translation helpful? Give feedback.
-
Hello,
I have recently bought several Sonoff TH origin THR316 devices and successfully flashed them with Tasmota, I cannot however, find any documentation on what to set the GPIO config for this device in order to get the correct reading for the attached THS01 rj11 sensor for Temperature/Heat/Humidity. It does display a Temperature by default, but it appears wrong by quite a lot.
Any help or suggestions please?
Beta Was this translation helpful? Give feedback.
All reactions