New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Potential short when installing knomi v2 according to manual!! - destroying your can board #50

Open

k4ndr3 opened this issue Dec 20, 2023 · 1 comment

k4ndr3 commented Dec 20, 2023

Manual flawed at pages 9, 10, 11
Expirienced the consequences 1st hand. Was not paying attention and destroyed my canbus board and the toolboard.

here is the problem:

the manual even shows you the consequence

KoiosLabs commented Jul 9, 2024

I put some uv solder mask on mine, would recommend similar... electrical tape... kapton... anything

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment