Replies: 4 comments 2 replies
-
what command are you using to apply the compose? and to confirm, you are not able to access the webUI at all? |
Beta Was this translation helpful? Give feedback.
-
First I tried "docker compose up" with the faulty setting, but later on, I have tried "docker compose restart", "docker compose start/stop". Same thing. |
Beta Was this translation helpful? Give feedback.
-
OK! Success, now I tried docker compose up again, and got webUI working! Will try to re-add my disabled cameras now. Thanks for the hint! |
Beta Was this translation helpful? Give feedback.
-
Is it best to always to up? |
Beta Was this translation helpful? Give feedback.
-
So, this is the first day of starting up my frigate setup. I installed one camera after the other, arrived to 5 cameras, where one would not give picture, so I looked in the log, and found a message saying shm size too small.
So I changed shm to 256, forgetting the 'mb' after, restarted and got errors saying
So I googled and found my mistake. Also found a recommendation to change to 2048mb, which I did. But still the same error message.
I have rebooted, and restarted docker compose many times now.
I tried to set the last couple of cameras 'enabled: false' but still the same problem.
Don't know what to do now. Wipe and re-install?
$ cat docker-compose.yml
`cat config/config.yaml
Beta Was this translation helpful? Give feedback.
All reactions