SDR++ Remote Screenshots Showing settings used

[K7MDL2]

Running SDR++ server on the Pi4B 2GB RAM (10% CPU), and SDR++ client on Windows 11 NUC12 (also works on the PI but CPU is very high which can lead to some audio stuttering).

You can see the settings here on the left side.

CaribouLite built from Main branch earlier with a few install script modifications and I/Q reversal patch. This build is from https://github.com/konimaru/cariboulite which includes those changes. I still add sudo in the install.sh script where it complains about lack of permission for the io tests.

This is on a long wire via a 4 port splitter so I can compare RX between my Teensy SDR, Elecraft K3, and a Hermes Lite 2. The AGC gain must be reduced to avoid pops in audio and spectrum. Here, my AGC gain is low then normal because I have a HF-VHF LNA in front. I have not tried transmitting yet.

Early on I was able to receive a weak signal source at 5760.1MHz from across the room on a 3" vertical antenna. Baby steps.

Here is 20M FT-8 late in the evening

In this I enabled FFT smoothing, upped the FFT Size, and framerate, adjusted FFT smoothing speed for a cleaner display.

Below is 40M FT-8 with further FFT adjustments to get a better display of the narrowband tracks.