You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello,
I am going to use Mowgli on my Yardforce NX100i.
The NX100i has a GForce RM-MB-V6.0.0 Mainboard so Mowgli will work (I have already flashed it ;-) ).
I have analysed some hardware pathes wich where not in the scematic of the 500 classic, for example the ultrasonic sensors and the perimeter signal.
During this analyse phase my robot stopt booting and I don't know why.
I know the controler is still working, because I can flash the Mowgli stuff.
So mayby I only destroyed the firmware while measuring.
Do somebody have an firmware backup of an NX Robot?
Or even better the protocol to the panel which i do not have analiese yet.
If someonw want to know some details about the perimeter or the ultrasonic sensors just ask ;-)
Regards
Georg
The text was updated successfully, but these errors were encountered:
Hello,
I am going to use Mowgli on my Yardforce NX100i.
The NX100i has a GForce RM-MB-V6.0.0 Mainboard so Mowgli will work (I have already flashed it ;-) ).
I have analysed some hardware pathes wich where not in the scematic of the 500 classic, for example the ultrasonic sensors and the perimeter signal.
During this analyse phase my robot stopt booting and I don't know why.
I know the controler is still working, because I can flash the Mowgli stuff.
So mayby I only destroyed the firmware while measuring.
Do somebody have an firmware backup of an NX Robot?
Or even better the protocol to the panel which i do not have analiese yet.
If someonw want to know some details about the perimeter or the ultrasonic sensors just ask ;-)
Regards
Georg
The text was updated successfully, but these errors were encountered: