-
Notifications
You must be signed in to change notification settings - Fork 0
/
README.txt
67 lines (45 loc) · 1.55 KB
/
README.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
Exar/MxL USB Serial Driver
======================
Version 1D 2021/9/14
Add GPIO operation support
Use dynamic allocate memory for usb_control_msg
Avoid re-configuring the flow mode if no changes
Remove obsoleted flag check for newer version
Fix XR21B142x incorrect register mapping
Fix baud rate setting for Big-Endian system
XR2280x wide mode setting
Clean up ident
Version 1C 2017/1/11
Add the 9-bit mode support.
Disable the debug messages.
Version 1B, 11/6/2015
Fixed Bug: The conditional logic to support kernel 3.9 was incorrect(line 396 in xr_usb_serial_common.c).
Version 1A, 1/9/2015
This driver will work with any USB UART function in these Exar/MxL devices:
XR21V1410/1412/1414
XR21B1411
XR21B1420/1422/1424
XR22801/802/804
The source code has been tested on various Linux kernels from 3.6.x to 5.11.x.
This may also work with newer kernels as well.
Installation
------------
* Compile and install the common usb serial driver module
# make
# insmod ./xr_usb_serial_common.ko
* Plug the device into the USB host. You should see up to four devices created,
typically /dev/ttyXRUSB[0-3].
Tips for Debugging
------------------
* Check that the USB UART is detected by the system
# lsusb
* Check that the CDC-ACM driver was not installed for the Exar USB UART
# ls /dev/tty*
To remove the CDC-ACM driver and install the driver:
# rmmod cdc-acm
# modprobe -r usbserial
# modprobe usbserial
# insmod ./xr_usb_serial_common.ko
Technical Support
-----------------
Send any technical questions/issues to [email protected].