-
|
Does anyone have a method to remove the create3 faceplate when it is stuck? I had never removed the faceplate but now would like to open the create3 to connect a raspberry pi 4. The method shown does not work. I put on gloves as well to really push counter clockwise but it will not move. Really locked in since manufacture. Is there a safe way to use a tool to apply more leverage? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
|
You can use a tool to tap on the tab help unstick things; we have a video of this posted; stand by while I look for the link. In the mean time, the adapter board comes out of the robot, if you are just trying to get access to the switch; just gently pull it out through the rear. It can help to stick a fingernail under the lip on the bottom edge. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you! Used a rubber mallet and a magic marker as in video. |
Beta Was this translation helpful? Give feedback.
-
|
Link to video for future searchers: https://youtu.be/UeLHrAvZ_h0?t=210 |
Beta Was this translation helpful? Give feedback.
You can use a tool to tap on the tab help unstick things; we have a video of this posted; stand by while I look for the link. In the mean time, the adapter board comes out of the robot, if you are just trying to get access to the switch; just gently pull it out through the rear. It can help to stick a fingernail under the lip on the bottom edge.