You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I wasn't sure whether or not these sketches are meant to work with Nintendo Switch Amiibo's?
I've tried to use the Dump_amiibo.ino but I keep getting the following errors:
Firmware Version: 0x92 = v2.0
Arduino amiibo reader. Put your NFC-tag to the reader
Read failed: A MIFARE PICC responded with NAK.
040002A8
Read failed: A buffer is not big enough.
040002A8
Read failed: A buffer is not big enough.
040002A8
Read failed: A buffer is not big enough.
040002A8
...
Dump finished! Now please take your Amiibo card away!
This error also occurs with tags as well and not just the Amiibo itself.
I'm using an Arduino UNO and the recommended breakout module RFID-RC522 reader/writer.
I can confirm that all my wiring is correct.
The text was updated successfully, but these errors were encountered:
I wasn't sure whether or not these sketches are meant to work with Nintendo Switch Amiibo's?
I've tried to use the
Dump_amiibo.ino
but I keep getting the following errors:This error also occurs with tags as well and not just the Amiibo itself.
I'm using an Arduino UNO and the recommended breakout module RFID-RC522 reader/writer.
I can confirm that all my wiring is correct.
The text was updated successfully, but these errors were encountered: