[BUG] Z-Home with Probe doesn't work after a print was canceled

[nicedevil007]

Bug Description

I start a print and cancel it after the printer is printing my objects.
Then the printer goes to it "print canceled position" and I start the print again (same gcode).

The printer homes X and Y and starts to home Z => the nozzle is ALWAYS crashing in the bed.

My hotfix for that is to reset the printer with the reset button on the display and start the print again.
Then everything is fine. 100% reproducable on my printer. The Z-Endstop is unplugged.

My Configurations

Required: I have installed the Almost Stock firmware.bin from you without any modifications. Oh it is the Biqu BX.

[totallynectar]

Did you ever figure this out? I had this exact issue but now my X home position is off the bed and now the sensor cant read the bed in order to Z home...