Docker installation tutorial - error during colcon build command

[JacksonWeil]

I run the colcon build command, and 158 / 370 packages finish, but then there is a series of errors. The first is: 'Bool' does not name a type (it is defined later). Then there is a long series of similar errors such as 'Pixmap' does not name a type; did you mean 'QPixmap'.

I would appreciate any help. I've tried installing several times and most prior errors seemed to by my fault due to missing dependencies, but this one is a bit more cryptic. Thank you.

[bmaxdk]

There's a mismatch between the libraries or headers being used during compilation, especially in a Docker environment. Could it be issue with correct verion of the library issue?

[JacksonWeil]

I'm not 100% sure what you mean but what you say sounds valid. I am trying to install following the 'source' directions now and I'm at 99/370 packages complete...

[JacksonWeil]

The same failure just occurred again - it fails on the package autoware_mission_details_overlay_rviz_plugin. I'm going to try to investigate more but if there are any ideas out there let me know. Also thank you @bmaxdk for your reply.

[bmaxdk]

I see..overlay_rviz_plugin issue. I seen this before which really annoyied me when I installed with source I also tried colcon build --packages-skip autoware_mission_details_overlay_rviz_plugin then installed and then re-build again.. I tried which someone suggest me to try but I faced another issue. Someone suggest the source the location as well. Hope you figure it out! Good luck

[JacksonWeil]

Ok thank you for the tip and your kind wishes. Currently I'm trying to reinstall my NVIDIA Driver, CUDA Toolkit, and gcc, thinking that maybe some combo of those are incompatible.