How to get Dehomogenization output from VABs

[sange000000]

I got this above lines in xml file (correct me if this is wrong, I got this somewhere from the internet)

with this I ran 'prevabs -i .xml -h -v' then 'vabs .sg'
The dehomogenization outputs are not generated. Is there something I'm missing here?

[unitasium]

The correct command is

prevabs -i <filename>.xml -d

then

vabs <filename>.sg 1

[sange000000]

Do I need the homogenized output, for executing the run to extract the demogenized ones?

when I run directly
prevabs -i .xml -d
then
vabs .sg 1

I get an error 'cannot open the file .sg for reading!'
But when I do the above 2 commands after doing these 'prevabs -i .xml -h ' then 'vabs .sg', I get the .sg.ELE file generated.
Also could you tell me what is the command to get .SN,.U,.SMN,.S,.EM,.EMN,.EN

[sange000000]

ex_airfoil_r_trial.zip
Attaching the files here

[unitasium]

Yes. You need to run homogenization first:

prevabs -i <filename>.xml -h
vabs <filename>.sg

then run recovery:

prevabs -i <filename>.xml -d
vabs <filename>.sg 1

After this, you should get the local stress and strain files.

[sange000000]

Thanks

[sange000000]

I still dont get the files : .sg.SN,.U,.SMN,.S,.EM,.EMN,.EN. only the following is generated .sg.ELE, opt,v,v1S,v22