D10ToggleTimer1.X

D10ToggleTimer1

Description

Toggle switch on/off the D10 LED @ 1 Hz using Timer1 Interrupt and SOSC as clock source.

Usage

• Set up the Developmnent Board:
  • Unplug the 9V power supply and the programmer from the development board.
  • Plug PIM to the development board.
  • Set switch S2 to PIM position.
  • Install the jumper JP2 to enable the LEDs.
  • Plug the 9V power supply and the programmer to the development board.
• Set up the project:
  • Open MPLAB X IDE.
  • Select "File -> Open Project..." from the MPLAB X IDE menu.
  • Select the project and click on "Open Project"
  • Right click on project name, select "Set configuration" and select the installed PIM.
• Run the project:
  • Right click on project name, select "Run"

Pinout

Indicator LEDs

LED	dsPIC33FJ256GP710A	PIC24FJ128GA010	Overlaps with	U	I
D3	RA0	RA0			x
D4	RA1	RA1			x
D5	RA2	RA2			x
D6	RA3	RA3			x
D7	RA4	RA4			x
D8	RA5	RA5			x
D9	RA6	RA6		x	x
D10	RA7	RA7	S5	x	x

U: Used, I: Implemented

16x2 LCD Display

LCD	dsPIC33FJ256GP710A	PIC24FJ128GA010	Overlaps with	U	I
E	RD4	PMWR		x	x
R/W	RD5	PMRD		x	x
RS	RB15	PMAO		x	x
DB0	RE0	PMD0		x	x
DB1	RE1	PMD1		x	x
DB2	RE2	PMD2		x	x
DB3	RE3	PMD3		x	x
DB4	RE4	PMD4		x	x
DB5	RE5	PMD5		x	x
DB6	RE6	PMD6		x	x
DB7	RE7	PMD7		x	x

U: Used, I: Implemented

ADC

Analog Input	dsPIC33FJ256GP710A	PIC24FJ128GA010	Overlaps with	U	I
Potentiometer	AN5/RB5	AN5/RB5
Temperature sensor	AN4/RB4	AN4/RB4

U: Used, I: Implemented

Oscillators

Oscillator	dsPIC33FJ256GP710A	PIC24FJ128GA010	Overlaps with	U	I
Primary: 8 MHz crystal (Y3)	OSC1/RC12	OSC1/RC12		x	x
Primary: 8 MHz crystal (Y3)	OSC2/RC15	OSC2/RC15		x	x
Secondary: 32.768 kHz (Y2)	SOSCI/RC13	SOSCI/RC13		x	x
Secondary: 32.768 kHz (Y2)	SOSCO/RC14	SOSCO/RC14		x	x

U: Used, I: Implemented

MPLAB ICD programmer/debugger module

ICD Pin	dsPIC33FJ256GP710A	PIC24FJ128GA010	Overlaps with	U	I
Vpp/!MCLR	!MCLR	!MCLR		x	x
PGD	PGED1/RB7	PGED1/RB7		x	x
PGC	PGEC1/RB6	PGEC1/RB6		x	x

U: Used, I: Implemented