Print a message in the LCD Display @ 16 MIPS
- Set up the Developmnent Board:
- Unplug the 9V power supply and the programmer from the development board.
- Plug PIM to the development board.
- Set switch S2 to PIM position.
- Remove the jumper JP2 to disable the LEDs.
- Plug the 9V power supply and the programmer to the development board.
- Set up the project:
- Open MPLAB X IDE.
- Select "File -> Open Project..." from the MPLAB X IDE menu.
- Select the project and click on "Open Project"
- Right click on project name, select "Set configuration" and select the installed PIM.
- Run the project:
- Right click on project name, select "Run"
| LCD | dsPIC33FJ256GP710A | PIC24FJ128GA010 | Overlaps with | U | I |
|---|---|---|---|---|---|
| E | RD4 | PMWR | x | x | |
| R/W | RD5 | PMRD | x | x | |
| RS | RB15 | PMAO | x | x | |
| DB0 | RE0 | PMD0 | x | x | |
| DB1 | RE1 | PMD1 | x | x | |
| DB2 | RE2 | PMD2 | x | x | |
| DB3 | RE3 | PMD3 | x | x | |
| DB4 | RE4 | PMD4 | x | x | |
| DB5 | RE5 | PMD5 | x | x | |
| DB6 | RE6 | PMD6 | x | x | |
| DB7 | RE7 | PMD7 | x | x |
U: Used, I: Implemented
| Analog Input | dsPIC33FJ256GP710A | PIC24FJ128GA010 | Overlaps with | U | I |
|---|---|---|---|---|---|
| Potentiometer | AN5/RB5 | AN5/RB5 | |||
| Temperature sensor | AN4/RB4 | AN4/RB4 |
U: Used, I: Implemented
| Oscillator | dsPIC33FJ256GP710A | PIC24FJ128GA010 | Overlaps with | U | I |
|---|---|---|---|---|---|
| Primary: 8 MHz crystal (Y3) | OSC1/RC12 | OSC1/RC12 | x | x | |
| Primary: 8 MHz crystal (Y3) | OSC2/RC15 | OSC2/RC15 | x | x |
U: Used, I: Implemented
| ICD Pin | dsPIC33FJ256GP710A | PIC24FJ128GA010 | Overlaps with | U | I |
|---|---|---|---|---|---|
| Vpp/!MCLR | !MCLR | !MCLR | x | x | |
| PGD | PGED1/RB7 | PGED1/RB7 | x | x | |
| PGC | PGEC1/RB6 | PGEC1/RB6 | x | x |
U: Used, I: Implemented