Is there any support for sleap-anipose (3D)?

[delaroob]

Hello everyone,

I'm trying to make 3D analysis work and it seemed logical to use sleap-anipose for triangulating 2D sleap data but I'm having some issues (charuco board corners are detected very innacurately during calibration).
The github page for the program seems a little dead, so I was just wondering if there is a way to get help with this?

Thanks in advance!

[ericleonardis]

Hello! Yes, I just replied to your issue on the sleap-anipose repo. Thanks for bringing this to our attention, let's get to the bottom of this.