Unable to jog router

[animasguitars]

I have been using UGS without any problem sending my post processor from Fusion 360 to my Shapeoko XL. Now it will not jog. It does the homing, but when I go to jog it to my project it just makes a noise. The numbers in the X, Y or Z change as if the router is moving, but it stays stationary. I also use "Inventables" and "Carbide Motion". The jog works in both.

[breiler]

Are you using a jog feed rate higher than your machine is cable of moving?

[animasguitars]

Don't think so. The rate is "1", I have never changed it.

…

On Fri, Aug 27, 2021 at 11:31 AM Joacim Breiler ***@***.***> wrote: Are you using a jog feed rate higher than your machine is cable of moving? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#1680 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AVMBCLQJ6SJQKA6R4API43LT67DYPANCNFSM5C57BLUQ> . Triage notifications on the go with GitHub Mobile for iOS <https://apps.apple.com/app/apple-store/id1477376905?ct=notification-email&mt=8&pt=524675> or Android <https://play.google.com/store/apps/details?id=com.github.android&referrer=utm_campaign%3Dnotification-email%26utm_medium%3Demail%26utm_source%3Dgithub>.

[breiler]

The rate is might be set too low then, have you tried turning it up.
For instance, if you are using metric units that would mean that it would move 1 mm/min.

[animasguitars]

That was the problem. I turned the rate up and now it works perfectly again. Thank-you so much. Obviously I am quite new to this and appreciate your help

…

On Fri, Aug 27, 2021 at 1:23 PM Joacim Breiler ***@***.***> wrote: The rate is might be set too low then, have you tried turning it up. For instance, if you are using metric units that would mean that it would move 1 mm/min. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#1680 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AVMBCLQA7U4ZCGK3N6APHBLT67Q25ANCNFSM5C57BLUQ> . Triage notifications on the go with GitHub Mobile for iOS <https://apps.apple.com/app/apple-store/id1477376905?ct=notification-email&mt=8&pt=524675> or Android <https://play.google.com/store/apps/details?id=com.github.android&referrer=utm_campaign%3Dnotification-email%26utm_medium%3Demail%26utm_source%3Dgithub>.