This project allows to bind TinkerForge sensors and actuators using MQTT to a central broker. The application is built using Spring Boot and is currently in a playground phase.
In order to build the software, please run mvn clean package from command line (you will require Apache Maven).
For configuration, make sure to copy the application.properties from docs folder and adjust the configuration.
In order to connect to the TinkerForge MasterBrick, the connection needs to be specified. Please use the following two values to configure the connection (the specified values are default):
#
# TF connection
#
tinkerforge.host=localhost
tinkerforge.port=4223
The sensor values are delivered to a MQTT broker, which has to be configured.
#
# MQTT connection
#
mqtt.broker=tcp://localhost:1883
mqtt.client.id=localtest
mqtt.qos=2
The MQTT protocol allows to create topics in a special way, so MQTT selectors (# and +) can be applied. In doing so, every MQTT sensor setup has a naming scheme which can be applied to the devices delivering the events. Usually this naming scheme is establishing a topology (physical or logical). The configuration is divided in three parts:
- Topic prefix of the entire application
- Topic segment for device
- Topic segment for measurement
The resulting topic is created by a concatenation of all three segments. The application topic prefix is configured by the property mqtt.topic.prefix. The device topic segment is configured using properties of scheme <uid>.topic=cellar where the <uid> is denoting the device UID of the bricklet. It is possible to configure multiple devices to point to the same topic. e.G.:
mqtt.topic.prefix=testsetup/
aDc.topic=cellar
hgY.topic=cellar
dfH.topic=cellar
In this setup, the three devices with given UIDs are located in cellar and deliver measurements to the same topic testsetup/cellar. The measurement topic is configured usgin the device specific setting (see next section).
Currently, the following sensor types are supported:
- Ambient light
- Barometer
- Distance Infra-Red
- Distance Ultra-Sound
- Hygrometer
- LCD 20x4 Buttons
- Scale
- Thermometer
- Thermometer Infra-Red
- Voltmeter
In addition, the following actuators are implemented:
- LCD 20x4 Text and Backlight
In general, you can configure every value sensor and set its value read timeout (callbackperiod) and the target topic (topic) based on the device type.
#
# Example ambient light
#
tinkerforge.ambilight.topic=illuminance
tinkerforge.ambilight.callbackperiod=10000
This will configure the ambient light to be checked every 10 seconds and deliver the value to testsetup/cellar/illuminance. In particular cases, it is important to configure a single device (not the device type). This can be done in a similar way, how the device segment is set.
#
# Example ambient light
#
aDc.callbackperiod=10000
To run the software just run `java -jar <mqtt-tinkerforge-boot-version.jar>