BabyBelt Pro (V2.5 , see branches for V1 or V2)
V2.5 changes - Print at 30 or 45 degrees. Better underbed, one Y linear rail. Better wire routing, Holes for run out and better mounting options for pi and more. Stronger bed tention system. Better gantry setup with X upgraded belt tention. Homes Y to bed. marlin needs update for full kit compatability.
TODO - better layout for slicer profiles, 30 vs 45.
0.2 MM layer height, 5 walls, 18% or so infill. Parts say if they need supports or number count.
I guess you can print it in anything other than TPU or PVA. I print most in PLA or PETG, Underbed must NOT be PLA for heat resistance reasons (ABS, PETG... Ok!)
Babybelt is here https://github.com/RobMink/BabyBelt
BOM https://docs.google.com/spreadsheets/d/19PbR3nFbQ4-eIOTU0kmoTl5-mHv_KsTnUdfFXekWg-I/edit?usp=sharing
Build Instructions (WIP, this is V1) - https://docs.google.com/document/d/1mQGLsETf6Q4ewTDiO3IRaFPFiom4OAmT2Igr8BftApE/edit?usp=sharing
Make your own belt - https://docs.google.com/document/d/13pu9LH_nKmDJY-V2nZXMY8CHur7INB6-9V5sKlAuCuE/edit?tab=t.0#heading=h.e01bdd2to5po
DISCORD: https://discord.gg/nVmeNJJSH2
Youtube: www.youtube.com/c/robmink
Facebook https://www.facebook.com/groups/632751915097010 - kinda inactive
If you wish to support the project : https://www.patreon.com/Printcepts
Non commercial, Att. Printcepts