BUILD STATUS

MAAPS

MAAPS - Machine Access And Payments System

MAAPS is a system for managing payments and access to machines designed to be used in Makerspaces. it uses RFID cards for authentification.

Hardware

• Raspberry PI
• Raspberry 3.5 inch Touch Display https://www.amazon.de/dp/B07YV5WYM3
• RFID card reader https://www.amazon.de/dp/B074S9FZC5
• Raspberry Pi Relay Board https://www.amazon.de/dp/B01FZ7XLJ4
• Buchsenleiste extra hoch https://www.amazon.de/dp/B07YDKX8SR/
• Jumper Wire Female-Female 10cm https://www.amazon.de/dp/B07GJLCGG8/

Pinheader	Raspi	Function	Hardware	Hint
Pin 1	3.3V	3.3V	RFID Pin 1	Löten, Pin belegt von LCD
Pin 34	GND	GND	RFID Pin 3
Pin 35	GPIO 19	MISO	RFID Pin 5
Pin 36	GPIO 16	CS0	RFID Pin 8
Pin 38	GPIO 20	MOSI	RFID Pin 6
Pin 40	GPIO 21	SCLK	RFID Pin 7
Pin 31	GPIO 6	Relais 3	Relais CH3
Pin 33	GPIO 13	Relais 2	Relais CH2
Pin 37	GPIO 26	Relais 1	Relais CH1	Jumper auf Relais board

Setup

Add devices to setup/devices.csv, edit setup/wpa_supplicant.conf to match your wlan.

Server

Execute these commands in the maaps-server-1 docker container

pip install -r requirements.txt
python3 manage.py migrate

On first install login to server now, run

python3 manage.py createsuperuser

to add your first user. Open the user admin page https://SERVERIP/webif/user/list, add firstname and lastname to admin user and save. Open the django admin page at https://SERVERIP/admin/, open the "Tokens" page and get the token identifier for admin (for example U:admin;4c31a8d19b95a7dfe85c)

Point of Sale

Install your first point of sale

python3 setup.py install <POS_IP>

After that, we must write our first admin RFID card. Login to the first POS, go to /home/{PI_USERNAME}/MAAPS/client/. Use the token you got from the token admin page

python3 hardware.py write "YOUR_ADMIN_TOKEN_HERE" 

After your first card was created, you can login on the POS with this card and create additional cards.

add prices

spaceRentPayment.daily
spaceRentPayment.monthly