Examples

• GPIO -- Arduino like GPIO functions
• GPIO_analogRead -- Arduino like analog input functions
• MCOtest -- How to route internal clocks to the external MCO pin
• adc_dma_opamp -- How to use DMA to read multiple A/D channels as well as how to use the op-amp
• adc_polled -- Simple A/D conversion example
• blink -- Blinks and LED on a GPIO. Demonstrates how to configure and manipulate GPIO
• bootload -- An basic bootloader
• debugprintfdemo -- How to use the high speed debug printf functionality of some of the programmers/debuggers
• direct_GPIO -- Shows basic GPIO setup and the different ways to manipulate GPIO output values.
• dma_GPIO -- How to use DMA to control GPIO output
• external_crystal -- How to use an external XTAL as a processor timesource (in the form of a blink program)
• exti_pin_change_isr -- How to use an external pin to trigger an interrupt routine
• i2c_oled -- How to use the I2C peripherial and an SSD1306 example library
• optionbytes -- How to program the option bytes which control some low level behaviors of the chip
• run_from_ram -- How to make code execute from RAM
• sandbox -- An example program to show how to use debug printf and debugging work
• self_modify_code -- An example to show how to write self modifying code
• spi_24L01_rx -- An example of how to use SPI and an nRF24L01 library to receive wireless data
• spi_24L01_tx -- An example of how to use SPI and an nRF24L01 library to transmit wireless data
• spi_dac -- How to setup SPI with DMA to control an external I2S DAC
• spi_oled -- How to use the SPI peripherial and an SSD1306 example library
• systick_irq -- How to setup the SYSTICK to generate periodic interrupts
• tim1_pwm -- How to use Timer1 (Advanced Control Timer) to generate PWM signals
• uartdemo -- How to use the UART peripherial
• ws2812bdemo -- An example of using the SPI peripherial with DMA to control WS2812B LEDs