Releases
v3.2.1
Added
support for IPv6 (web/api/mqtt, not syslog yet) #83
System Log in Web UI will show current time if the NTP Service is enabled #82
Network settings for Tx-power, WiFi-bandwidth, WiFi-sleepmode #83
optional low CPU clockrate (160 MHz) #83
select format for enumerated values in web
settings for water hysteresis on/off
dallas sensor name editable. sensorname
console-command, replace sensorid with a unique name #84
'restart' system command. Can be invoked via API with authentication. #87
add Download button in Web UI for log
json body in API can now take device, name, cmd, hc and id
added example of how to use API directly to control values from Home Assistant
API calls are shown in debug log (For troubleshooting)
Fixed
set mode allow numbers
Junkers thermostat shows mode as selected by set_mode
HA thermostat mode if bool-format: numbers is selected
Web UI System Log sometimes skipped a few log messages when watching real-time
fix wwactivated #89
don't show commands (like reset) as Device values in the Web or Console
fixed issue with Home Assistant entity naming where boiler's ww was duplicated in entity name
fixed issue where wwSetTemp was written too instead of wwSeltemp
Changed
removed Rx echo failures counting as incomplete telegrams. Bad telegrams show as Warning and not Errors. #80
add upload_sec to api/system/info
and removed # from some names to keep consistent with MQTT heartbeat
added debug target to PlatformIO build to help hunt down system crashes
enumerated values always start at zero
maintenance settings for time/date as extra setting
move api/mqtt formats to settings
, add enum format
UI improvements for editing Dallas Sensor details
RESTful GET commands can also require authentication (via bearer access token) for better security
Updated AsyncMqttClient to 0.9.0 and ArduinoJson to 6.18.3
Download buttons for settings and info under the Help tab
fixed case on mqtt names, like 'wwtankmiddletemp'
renamed Product ID to 'EMS Product ID' in Home Assistant
removed brackets around tags, e.g. (hc1) selected room temperature" is now just "hc1 selected room temperature"
You can’t perform that action at this time.