Merge branch 'main' into main

projects/!!!Shaunak's-Usb-c-hub!!!/README.md

@@ -0,0 +1,14 @@
+---
+name: "SHAUNAK BAJAJ"
+slack_handle: "@Not_Skibidi_Its_Sigma"
+github_handle: "@MRKillerShaunBa"
+tutorial: NO TUTORIAL FOLLOWED
+---
+
+# Shaunak's-USB-C-Hub
+
+<!-- USB hub with 1 to 3+1 config. (the +1 is a female usb-c port) -->
+
+<!-- $43.67 USD -->
+
+<!-- I had to source a usb-c which was a big challenge as it needed to comply with JLCPCB economic standards-->

projects/Abinisha NFC/README.md

@@ -0,0 +1,13 @@
+---
+name: "Abinisha Thirukumar"
+slack_handle: "@Abinisha Thirukumar"
+github_handle: "@Abinisha14"
+tutorial: # Link to the tutorial if you used one
+---
+
+# Abinisha NFC
+
+ This is a project I made at my high school for stem club. This PCB can light up 
+
+$31.48 
+

projects/Arduino_Reciever/README.md

@@ -0,0 +1,16 @@
+---
+name: "Anshuman Tripathy"
+slack_handle: "@Anshuman Tripathy"
+github_handle: "@ANSHUMANDOCX"
+tutorial:
+---
+
+# ARDUINO_RECEIVER
+
+<!-- Describe your board in 2-3 sentences. What are you making? What will it do? -->
+It's an Arduino 10-channel receiver circuit. It can receive data via an RF24L01 transmitter.
+
+
+<!-- How much is it going to cost? -->
+Ordering it with other two pcb total cost is about 27$
+<!-- Tell us a little bit about your design process. What were some challenges? What helped? ***Totally optional*** -->

projects/Brendan ArmLED/README.md

@@ -0,0 +1,16 @@
+---
+name: "Brendan Lee"
+slack_handle: "@Bre"
+github_handle: "@Brelee2222"
+tutorial: # Link to the tutorial if you used one
+---
+
+# YOUR PROJECT NAME
+
+<!-- Describe your board in 2-3 sentences. What are you making? What will it do? -->
+The board is an LED controller for LEDs you put on your arms. They have voltage regulators on it. 
+
+<!-- How much is it going to cost? -->
+$44.45 for 3
+
+<!-- Tell us a little bit about your design process. What were some challenges? What helped? ***Totally optional*** -->