JitStreamer Installation Guide

This guide will walk you through the process of installing and running JitStreamer on your host computer and iPhone.

Computer Setup

Prerequisites

• Python 3.10 or higher
• Git
• Tailscale account

General Steps

1. Install Tailscale on both your host computer and iPhone
2. Create and activate a Python virtual environment
3. Install JitStreamer
4. Run JitStreamer

Linux/macOS Instructions

1. Install Tailscale

   • Visit the Tailscale download page
   • Follow the instructions for your specific Linux distribution or macOS

2. Create and activate a virtual environment

   python3 -m venv jitstreamer_env
   source jitstreamer_env/bin/activate
   

3. Install JitStreamer

   pip install git+https://github.com/jawshoeadan/JitStreamer#egg=JitStreamer
   

4. Run JitStreamer

   sudo JitStreamer
   

Windows Instructions

1. Install Tailscale

   • Visit the Tailscale download page
   • Download and run the Windows installer

2. Create and activate a virtual environment

   python -m venv jitstreamer_env
   jitstreamer_env\Scripts\activate
   

3. Install JitStreamer

   pip install git+https://github.com/jawshoeadan/JitStreamer#egg=JitStreamer
   

4. Run JitStreamer (as administrator)

   • Open Command Prompt as administrator

   JitStreamer
   

Phone Setup

1. Install Tailscale on your iPhone

   • Open the App Store on your iPhone
   • Search for "Tailscale"
   • Download and install the Tailscale app

2. Configure Tailscale

   • Open the Tailscale app
   • Follow the in-app instructions to connect to your Tailscale network

3. Install this shortcut and follow the setup questions. After you connect both of your devices to Tailscale, you can view each device's IP address from the dashboard. Use the same pairing file you used to setup SideStore. If you don't know the UDID of your device, it is typically the file name of your pairing file

4. Before you can enable JIT, you have to run the shortcut, first clicking "Start Tunnel", then again clicking "refresh devices".

5. To enable JIT on apps, go into the SideStore settings -> SideJitServer and manually set the server IP to be the IP of your server, include http:// and :8080 at the end

Troubleshooting

If you encounter any issues during the installation or running of JitStreamer, please check the following:

1. Ensure Tailscale is properly installed and connected on both your host computer and iPhone.
2. Verify that you're using the correct version of Python (3.10 or higher).
3. Make sure your virtual environment is activated before installing and running JitStreamer.
4. If you get a "command not found" error, try using the full path to the JitStreamer executable.
5. In a web browser open http://server-ip:8080/ and you should see your device. If you don't, try running the shortcut with "refresh devices"
6. Try running clear tunnels then start tunnel again