Skip to content

SkyView Pico. Quick start

Linar Yusupov edited this page May 31, 2023 · 1 revision

Raspberry Pico W

  1. Take an appropriate version of the SkyView firmware from this location ;

  2. Press and keep holding BOOT button of the Raspberry Pico W ;

  3. Connect the Pico W to your PC by means of a USB cable (Type-A <-> micro Type-B) ;

  4. Release BOOT button of Pico W. A virtual disk with RPI-RP2 label should appear in your "File manager" afterwards ;

  5. Drag the downloaded firmware file by your pointing device (mouse, trackball,...) , then drop it into RPI-RP2 disk. Wait until the file transfer is complete ;



  1. Follow instructions for SkyView EZ starting from Step 3.

Banana BPI-PicoW-S3

  1. Take an appropriate version of the SkyView firmware from this location and unzip the archive ;

  2. Connect the Banana BPI-PicoW-S3 to your PC by means of a USB cable (Type-A <-> micro Type-B) ;

  3. Press and release RESET button of the Banana device two times. A virtual disk with UF2BOOT label should appear in your "File manager" afterwards ;

  4. Drag the downloaded .uf2 firmware file by your pointing device (mouse, trackball,...) , then drop it into UF2BOOT disk. Wait until the file transfer is complete ;



  1. Follow instructions for SkyView EZ starting from Step 3.

Hardware

SoftRF

SkyView

Flight Recorder

Adapters

Software

Firmware

Tools

Protocols

Clone this wiki locally