FLSun Super Racer Config Files

These config files are for my highly modified FLSun Super Racer.

Based on code from:

• https://github.com/danorder
• https://github.com/Guilouz

Modifications

• Custom PLA Effector
• OMG V2 Extruder
• 2x 5015 Blower Fans
• B-metal heatbreak
• CHC Pro
• CHT Volcano spacer
• 0.6mm CHT Nozzle
• Custom AC heated bed
• 300mm (280mm printable) PEI Mag Plate
• Capricorn Bowden Tubing
• WD40 Specialist Dry Lube

Planned Modifications

• Mosquito Magnum (prototyping a new effector)
• Beacon ABL (also prototyping in the new effector)
• Flying Extruder
• Heated Enclosure

Movement Limitations

• 400mm/s @ 240,000mm/s²
• 1000mm/s @ 23,000mm/s²

Typical Print Profile Workflow

1. Calibrate my filament for maximum quality.
2. Find the maximum flow of the filament while maintaining quality, typically 10-20% less than true maximum.
3. Set the maximum flow for the filament in my slicer, usually OrcaSlicer.
4. Set initial layer height to 0.45.
5. Set other layers to 0.15mm.
6. Set other print settings as needed, this should result in most of the print at maximum flow for the filament.