Pre requisites

Pre-requisites

The computer running Net::UDAP and your SBR must be connected to the same wired network, and must be on the same subnet. This network must be connected to the first network interface on the computer, in order for SBR discovery to work. If your SBR is on a network interface other than the first you must either move it, or configure down any preceding network interfaces, until it is so assigned. Otherwise the discover command will not find your SBR [this is tracked in Ticket #6; now fixed in the trunk]. Make sure port 17784 (UDP) is open in your firewall, and UDP broadcast traffic is allowed. Your SBR should be in "init" mode: press and hold the button for around six seconds until the LED flashes red quickly release the button and the receiver will reset and come up in init mode - the LED will flash red slowly