docs(preamble): 📝 move auto-save section into precourse tasks (#187)

## Description

It didn't make any sense that the auto-save section was during the
session, it makes more sense in the pre-course tasks. So moved it.

Closes #158

## Checklist

- [x] Ran spell-check
- [x] Formatted Markdown
- [x] Rendered website locally

preamble/pre-course.qmd

@@ -46,11 +46,13 @@ about them are found as you work through this section.
 10. Run a check using `r3::check_project_setup_advanced()` to see that
     everything is as expected. You'll later need to paste this output
     into the survey.
-11. Read about the basic course details in @sec-course-details.
-12. Read the syllabus in @sec-syllabus.
-13. Read the [Code of
+11. Set up some quality of life options in RStudio in
+    1.  
+12. Read about the basic course details in @sec-course-details.
+13. Read the syllabus in @sec-syllabus.
+14. Read the [Code of
     Conduct](https://guides.rostools.org/conduct.html).
-14. **Complete the pre-course
+15. **Complete the pre-course
     [survey](https://docs.google.com/forms/d/e/1FAIpQLSfzTLrLFyQHj79YGaCQDN5fUZ_9et1qdmtDGiq6gNPGzFSCyQ/viewform?usp=sf_link)**.
     This survey is pretty quick, maybe \~10 minutes.
 
@@ -403,6 +405,19 @@ doesn't, start over by deleting everything in the `data-raw/` folder
 again. If your output looks a bit like the above, than copy and paste
 the output into the survey question at the end.
 
+## Set up some quality of life options {#sec-quality-of-life}
+
+Some of the most common "issues" we encounter in the course when it
+comes to Git are caused by files not being saved so the changes can't be
+seen by Git. To help with this, we suggest turning on some options in
+RStudio. While, there are many options inside the Global Options in
+RStudio that can help you work better and faster, the two we want you to
+to use will help you and us out during the course:
+
+-   Go into `Tools -> Global Options -> Code -> Saving`.
+    -   Under the heading "General", tick on all of those check boxes.
+    -   Under the heading "Auto-save", tick on both those check boxes.
+
 ## Course introduction {#sec-course-details}
 
 Most of the course description is found in the syllabus (@sec-syllabus).

sessions/smoother-collaboration.qmd

@@ -582,18 +582,6 @@ Since this mode is on automatically in the `doc/learning.qmd` file, as
 we work through the sessions, we'll get lots of experience using it.
 We'll also eventually switch so that the whole project uses this mode.
 
-## Exercise: A few small changes to improve your workflow
-
-> Time: \~2 minutes.
-
-There are many options inside the Global Options in RStudio that can
-help you work better and faster. There are a few that will help a lot,
-especially in this course and with the workflows we are showing:
-
--   Go into `Tools -> Global Options -> Code -> Saving`.
-    -   Under the heading "General", tick on all of those check boxes.
-    -   Under the heading "Auto-save", tick on both those check boxes.
-
 ## Exercise: Update the README file, while using canonical markdown mode
 
 > Time: \~10 minutes.