Commit
This commit does not belong to any branch on this repository, and may belong to a fork outside of the repository.
net: enetc: disable Tx BD rings after they are empty
The Tx BD rings are disabled first in enetc_stop() and the driver waits for them to become empty. This operation is not safe while the ring is actively transmitting frames, and will cause the ring to not be empty and hardware exception. As described in the NETC block guide, software should only disable an active Tx ring after all pending ring entries have been consumed (i.e. when PI = CI). Disabling a transmit ring that is actively processing BDs risks a HW-SW race hazard whereby a hardware resource becomes assigned to work on one or more ring entries only to have those entries be removed due to the ring becoming disabled. When testing XDP_REDIRECT feautre, although all frames were blocked from being put into Tx rings during ring reconfiguration, the similar warning log was still encountered: fsl_enetc 0000:00:00.2 eno2: timeout for tx ring #6 clear fsl_enetc 0000:00:00.2 eno2: timeout for tx ring #7 clear The reason is that when there are still unsent frames in the Tx ring, disabling the Tx ring causes the remaining frames to be unable to be sent out. And the Tx ring cannot be restored, which means that even if the xdp program is uninstalled, the Tx frames cannot be sent out anymore. Therefore, correct the operation order in enect_start() and enect_stop(). Fixes: ff58fda ("net: enetc: prioritize ability to go down over packet processing") Cc: [email protected] Signed-off-by: Wei Fang <[email protected]> Reviewed-by: Vladimir Oltean <[email protected]> Link: https://patch.msgid.link/[email protected] Signed-off-by: Jakub Kicinski <[email protected]>
- Loading branch information