Shell script to install a Tec-AX Masternode on a Linux server running Ubuntu 16.04. Use it on your own risk.
wget -q https://raw.githubusercontent.com/zoldur/Tecax/master/tecax_install.sh
bash tecax_install.sh
After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet
- Open Tecax Core Wallet.
- Go to RECEIVE and create a New Address: MN1
- Send 1000 TECAX to MN1.
- Wait for 15 confirmations.
- Go to Tools -> "Debug console - Console"
- Type the following command: masternode outputs
- Go to Tools -> "Open Masternode Configuration File"
- Add the following entry:
Alias Address Privkey TxHash Output_index
- Alias: MN1
- Address: VPS_IP:PORT
- Privkey: Masternode Private Key
- TxHash: First value from Step 6
- Output index: Second value from Step 6
- Save and close the file.
- Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
- Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is un
- Select your MN and click Start Alias to start it.
tecax-cli mnsync status
tecax-cli getinfo
tecax-cli masternode status #This command will show your masternode status
Also, if you want to check/start/stop tecax , run one of the following commands as root:
systemctl status Tecax #To check the service is running.
systemctl start Tecax #To start Tecax service.
systemctl stop Tecax #To stop Tecax service.
systemctl is-enabled tecax #To check whetether Tecax service is enabled on boot or not.
If your Tecax Core Wallet doesn't sync, go to Tools -> Open Wallet Configuration File and add the following entries:
addnode=199.247.1.163
addnode=199.247.30.21
Any donation is highly appreciated.
TECAX: TQg6yV3MeV5tip7qCAEG2mwkrAV9Ahz6HV
BTC: 3MQLEcHXVvxpmwbB811qiC1c6g21ZKa7Jh
ETH: 0x26B9dDa0616FE0759273D651e77Fe7dd7751E01E
LTC: LeZmPXHuQEhkd8iZY7a2zVAwF7DCWir2FF