User Guide: Battery Configuration
Most boards CANNOT tolerate more than 3.3V brought into them. Make sure you are using an appropriate sensor for your board, such as this one
Some boards require you to enable the ADC pins. E.g. Sparky you must select an OutPort in the hardware page with ADC functionality.
- Enable the Battery module using the Modules - Enable page.
- Reboot the board
- Go to the battery tab within the modules page
- Assing whichever pins are used for voltage and current
- Update the scales from the table below. Note the offset factors will probably be incorrect and need to be adjusted for your particular sensor and board.
| Sensor | Voltage Factor mV/Volt | Voltage Offset V | Current Factor mV/Amp | Current Offset |
|---|---|---|---|---|
| AttoPilot 180A | 63.69 | -0,15 | 18.30 | -0,6 |
| AttoPilot 90A | 63.69 | -0,15 | 36.60 | -0,6 |
| RCTimer 90 A | 63.69 | -0,15 | 36.60 | -0,6 |