User Guide: FlyingPI Setup

FlyingPI Setup

WORK IN PROGRESS

Build FlyingPIO Hardware

Pre-Requisites

• Fetch the hardware design files and documentation
• Get some PCBs manufactured (OSH Park is known to be good)
• Obtain all the components listed in the BoM
• A Raspberry Pi 2 or later (not zero, compute etc.)

Assembly

• BMX055 requires care
• OSRAM LED markings are confusing, the little mark/arrow goes away from the line toward the cathode
• Test with current limited bench supply on battery pins, 12 V 100 mA or so, make sure no smoke, super-low current, check 5 V on 5 V pins
• Test with 3V3 on 3V3 pins, make sure super-low current/no smoke
• Press header onto Pi extension connector

Build Firmware

• Requires dRonin build environment
• Install arm toolchain: sudo apt install gcc-arm-linux-gnueabihf
• PI_CROSS_SIM=yes make sim
• make ef_flyingpio

Setup PI

• Obtain latest Raspbian image, lite is fine (2017-04-10 is known to work).
• Unzip, write to your SD Card (umount /dev/sdX1 etc., dd bs=4M status=progress if=20xx-xx-xx-raspbian-jessie-lite.img -of /dev/sdX)
• Enable SSH on first boot (mount the SD card (reinsert on desktop distros), cd into boot partition, touch ssh)
• Connect Ethernet and power up Pi
• Enable SSH (semi?)permanently, ssh into Pi and sudo raspi-config > Interfacing Options > SSH
• Copy flyingpi.cfg, flyingpio.dts, flyingpio_eeprom.txt from flight/targets/flyingpio, sim.elf from build/sim-pi, and ef_flyingpio.hex from build/flyingpio/ to home dir on pi
• Proceed with icee steps... https://gist.github.com/mlyle/debcc19c503e9e62dbe46d7a0a3dc519