-
Notifications
You must be signed in to change notification settings - Fork 26
Digilent Atlys Board: Switches, Buttons and Status LEDs
Tim Ansell edited this page Apr 20, 2014
·
6 revisions
Button | Name | |
---|---|---|
BTNU (N4) | ??? | ??? |
BTNL (P4) | ??? | ??? |
BTNR (F6) | ??? | ??? |
BTND (P3) | ??? | ??? |
BTNC (F5) | ??? | ??? |
Led | Name | |
---|---|---|
LED[0] | usb_error | turns on when there is any over flow or under flow in usb fifos... not necessarily critical error. |
LED[1] | ram_error / jpeg_error | critical error. usually systems will not work. if it cant recover its self. if error is in RAM a reset is required. |
LED[2] | jpeg_busy | if blinking shows the activity in jpeg encoder. if off means encoder is off if constant on means waiting for either input or space in out put(usb) fifo. |
LED[3] | vsync | vertical sync of HDMI/DVI signal. |
LED[4] | rgb_de; | data enable signal of HDMI/DVI signal. |
LED[5] | (flagB) | cypress chip fifo flags blinking shows activity between fpga and cypress chip. |
LED[6] | (flagC) | same as above |
LED[7] | if high after toggling sw0 means external monitor is DVI if low means external monitor is HDMI |