USB IDs
- Unconfigured - The board has booted without any firmware and just read the initial USB IDs
- Firmware load/upgrade - The board has been loaded with firmware (via the PC, or from Flash/EEPROM) for programming the FPGA / flash / eeprom.
- Normal operation - The board has been loaded with firmware (via the PC, or from Flash/EEPROM) for HDMI capture (appearing as a multifunction UVC and CDC class device)
The Openmoko project has provided the HDMI2USB with the following real USB IDs;
| Vendor ID (VID) | Product ID (PID) | Description |
|---|---|---|
| 0x1d50 | 0x60b5 | TimVideos' HDMI2USB (FX2) - Unconfigured device |
| 0x1d50 | 0x60b6 | TimVideos' HDMI2USB (FX2) - Firmware load/upgrade |
| 0x1d50 | 0x60b7 | TimVideos' HDMI2USB (FX2) - HDMI/DVI Capture Device |
| 0x1d50 | 0x60b8 | TimVideos' HDMI2USB (Soft+UTMI) - Unconfigured device |
| 0x1d50 | 0x60b9 | TimVideos' HDMI2USB (Soft+UTMI) - Firmware upgrade |
| 0x1d50 | 0x60ba | TimVideos' HDMI2USB (Soft+UTMI) - HDMI/DVI Capture Device |
-
FX2 - Device using a Cypress FX2 chipset for the USB interface. This is the IC used on the Digilent Atlys board.
-
Soft+UTMI - Devices uses a low cost UTMI IC coupled with a "Soft USB core" running on the FPGA.
